Hi ,what the accurate method to set correct(In) over load to
protect the 3~ motor
- 4 Answers
- 3610 Views
- I also Faced
- E-Mail Answers
Answer Posted / joseph
The correct setting of over load relay is 105% of full load current.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How many double suspension hardware fittings are required on a double circuit transmission tower?
How to calculate cable rating for 3 phase supply?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
Why neutral is not used in three phases dol starter
What are the advantages of speed control using thyristor?
An active element is one which a. Supplies energy b. Absorbs energy c. Supplies energy and convert energy from one form to another
how can calculation ate Amps for cabel. Ex-for 1sqmm wire hou many amps we can draw
how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com
Why Stabilising Resistor used in REF circuit ?
if a.c supply is given to the motor,, what happen?
how to determine ct ratio in ht vcb?
Define bibo stability.
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
testing of Vector Group – YNaoD II
