why we create vaccume in transformer tank before oil
filteration?
Answer Posted / k.prakashchandra
To dehydrate the windings.In view of high level of water /
moisture content in insulation ,it is recommended to
thoroughly dehydrate the windings by subjecting to vacuum
heating and drying after untanking the oil.Care should be
taken to see that the tank would not buckle due to the vacuum.
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???
What is the use of bundle conductors?
I want to know Electrical Circuit?
Hi guys! Plz help me to answer the following questions. 1. What are the types of transmission line energy losses? 2. Why are the VLF are used some types of services? 3. What frequencies are used for reliable beyond the horizon terrestrial communication without repeaters? 4. To permit selection of 1 out 16 equi-probable, what is the number of bitis required? 5. What is the most common modulation used for telegraphy? 6. What is the multiplexing is used to increase the capacity of the optic fiber? Thanks
What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?
What are the protections for safe running of electric generator?
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
what is transient enclosure vltage , very fast transients, very fast transient over voltages
If 24 KVA AVR having Input voltage 200-400v, Output voltage 415+-1%, what will be the voltage if Load is 13A.
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
what is the relation between reactive power and power factor for the what is the limit of reactive power and power factor
Which is the oldest hydropower plant in india?
what is the earth current,reverse power,electrical trip generator short circuit,low voltage, high voltage please discribe me
what exactly commisioning work does in electrical site work... LT side?..