Interested to Buy Any Domain ? << Click Here >> for more details...
does the design & fittings vary on the type of the vehicle
engine.. why they use petrol for engines only & vice versa..
- 2 Answers
- 6992 Views
- Toyota, I also Faced
- E-Mail Answers
Answer Posted / ankur verma
No, the type of fitting & design does not vary for automotive
segment. Its the same. However, its different in case of
aerospace & other sector.
In the fittings, usually of hole/shaft one of those is made at
the basic size so that it can accommodate the other one.
| Is This Answer Correct ? | 7 Yes | 9 No |
Post New Answer View All Answers
Discuss the Otto cycle.
List 5 words that best Describe your strengths? List 5 words that best Describe your weakness?
Why does a compression engine use high –octane fuel?
What do you mean by independent suspension?
Do the design & fittings depend on the type of the vehicle engine? Why is petrol used for engines only & vice versa.
Why dtsi technology is used in motor bikes?
If the tractive effort is the highest for a given velocity, then the vehicle must be in a) Top gear b) Third gear c) Second gear d) First gear
If two shafts used for transfer of drive are inclined to each other, then a) Slip joint is used b) Flange coupling is used c) Universal joint is used d) None of the above
What is overflow and how it's happen
How does the thermostat work?
State two to three differences between two stroke and four stroke engine?
How bhp is measured?
The main advantage of a good clutch is a) Good torque transmission b) Rapid engagement c) Large size d) High inertia
Define riveted joints.
Why I/P transducer is connect with 24V DC not to 220V AC?
