Interested to Buy Any Domain ? << Click Here >> for more details...
what will happened if generator runs with slow speed?
- 3 Answers
- 6039 Views
- I also Faced
- E-Mail Answers
Answer Posted / manikandan
If it is a induction generator residual voltage of 20v will
be as an output for other generators there will be no output
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
How do we calculate the Out put voltage of generator, after the excitation is being given?
What is the effect of positive feedback on the stability of the systems?
DC transmission
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
what is is the potential diffrence between two phase ?
difference between servo motor and synchronous motor
how tto ingress mw in turbine explain.procedure ?
How to measure current and voltage in an ELV circuit
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
what is active power & reactive power?
what is the difference between megger and earth resister ??
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
