Interested to Buy Any Domain ? << Click Here >> for more details...
Can the same motor be operated in both direction ?
- 12 Answers
- 17321 Views
- I also Faced
- E-Mail Answers
Answer Posted / anand
need to be more specific to ask question i.e. ac or dc
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
WHAT IS THE FUNCTION OF SHORT CIRCUIT MAINTENANCE CT
how to select proper cable for ct wiring so that drop within the limit.
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
what is the purpose of high speed earth switch in gas insulated substat
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
I use 20 nos led tube 4feet, in pathway 100mtr approximate, so what size cable i use for lighting
Why the unit sizes of hydro generating machines are not standardized as in case of thermal powerplants?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
WHAT IS THE PARTIAL DISCHARGE TEST?
How to work meggar?
Why auxiliary transformers are not connected in parallel in primary stations?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
Explain few advantages of electric traction system?
How may I get the maximum current capacity for a particullar size Alluminum or Copper cable if there is compulsion to use?
