Interested to Buy Any Domain ? << Click Here >> for more details...
why capacitors cant used in genset to maintain power factor..??
- 2 Answers
- 5322 Views
- I also Faced
- E-Mail Answers
Answer Posted / n k singh
The main purpose of capacitor is to generate reactive power
and hence improves the power factor.Therefore it must be
installed at load end otherwise if we install at source end
then there will be transmission loss till the load
point,which is undesirable,hence it must be at load end.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what kind of technical test that i need to learn because i have an interview tomorrow.. please someone help me..
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
What is power relay?
what is spadar bar .why I use in DC generator.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
What are the various types of rotor used in the alternators?
how does commutator convert a.c to d.c?
what is integrated ac contact circuit
why in a swquence network representation, the negetive sequence generated voltage is taken as zero?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?
explain transformer ct connection?
what is the maintaining Cf in UPS.
