Interested to Buy Any Domain ? << Click Here >> for more details...
why we r using 4-20ma instead of 0-20ma in instrumentation
- 2 Answers
- 6001 Views
- EID Parry, I also Faced
- E-Mail Answers
Answer Posted / ind/elec
4-20 ma is used as opposed to 0-20 ma as at 0 ma this could
because of a break in cable or loss of supply and so
control would be ineffective.
| Is This Answer Correct ? | 2 Yes | 6 No |
Post New Answer View All Answers
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
List advantges of active filter over passive filter?
how is the cable tray designed & how its total length is calculated for an Industrial plant Say for Ex. (500KW Motor Load)
Please explain me about Relay curves and their sources to read ?
describe the A.C. Generator Testing procedure
why the projects getting loss?
What is line resistance of cable & how it can be measured ?
gas turbine genrator reactances
What OPGW is better than Microwave or PLCC???
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
What is the function of attenuator in cro?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
How can a equal potential zone be carried out in conductors?
