what is plc? Basic function of plc? application of plc in
industry? What is lader diagram ? What is the main advantage
to use plc in industry?
- 15 Answers
- 101997 Views
- Schlumberger, I also Faced
- E-Mail Answers
Answer Posted / priyaloges
The PLC is a controller device which is used to control the
logically automated systems.It replaces relays to a single
PLC.Fuctions are motion control, process control, networking
control,distributed controletc.,
| Is This Answer Correct ? | 45 Yes | 13 No |
Post New Answer View All Answers
what is piezoelectric transducer?give an example in power plant n state its principle?
Explain the burnout feature.
Boolean algebra
principle of automatic votage regulator
List three types Level Gauges with their working principles
whatis range of marcury filled tempereture gague
How ejector(or)evactor air pump is working in thermal power plant?
all types instrumentation questions want
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How to Calibrate Ultrasonic flow Transmitter in Field
any body please send me the old question papers of ongc test.
How would you choose differential range?
If i have 4 Allen Bradely make RS logix 5000 PLC and for viewing that we are using 4 RS view SCADA for 4 different packages. Now, I will want to view two packages on only one SCADA. Then how i will do it?
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
