Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / guest
frequency is depends upon the requirement, we can vary the
frequency of the supply in the generator by increasing the
rpm , frequency 50 hz is better because many of the losses
in the transmission and distribution is also depends on the
frequency
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the purpose of stand by earth fault protection for transformer ?
What is self exciting?
What are the three types of compensators?
why zero sequence impedance measurement is not applicable for single phase GT
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
how to setting voltage RTCC panel
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
can you plz send l&t aptitude questions if available its urgent plz plz plz
3phase motor can be used as a Prime mover for alternator.
ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com
How the over load setting for HT Motors calculated-provided in Numerical Relay
Single line digram for 11 kV to distribution use go,la and do
What is I to C?
