Interested to Buy Any Domain ? << Click Here >> for more details...
Why there are semi conductor layers on conductor and XLPE
insulation of HT cables
- 1 Answers
- 3634 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
To influence electric field within the insulation
layer.These layers are not doped and are intrinsic.They
insure that the electrical stresses spread evenly and safely
within the insulation as the cable is not provided with lead
sheath.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
what is effect of length of air gap on performance of dc motor and generator?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What is the function of a neutral reactor.
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
sir please tel me how calucalte kwh if home taken load 30ams how maney kwh taken per day.and 3phase motor 5hp per hars how maney load teken and how mach kwh and forward me to electrical table for calicalte kwh and kvr and kvah
What is the difference between electronic regulator and ordinary electrical rheostat regulator for fans?
What is the actual calculation for transformer short circuit test?.
Usage of flywheel diode in relays
sail kaott diploma ece ke interviw me qus.kis parkar ke aate hai aur G.S me kya puchate hai kya sameedyaan me kis parkar ke qu.puchate hai
WHICH SIZE A.B.CABLE IS USED FOR 11KV.
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
Why a tesa lamp is glow between two phase?
Explain about retrofitting of machine tool.
