Interested to Buy Any Domain ? << Click Here >> for more details...
why earth hole size is biggest in plug point?
- 22 Answers
- 44225 Views
- Al Qabas, HCL, RRB, I also Faced
- E-Mail Answers
Answer Posted / mohanraj
to A.senthil Kumar
can u explain this in another way which can be under
standable by every one ok plzzzzzzzzz
| Is This Answer Correct ? | 2 Yes | 10 No |
Post New Answer View All Answers
What is dynamo?How it works and what is the function of dynamo in a DG.
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
how to set relay setting? and example calculation...
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
Enlist four components of electrive drives.
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
can we find the inductance of a induction motor?
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
how can we phase identification in a distribution line,how we recognise that which phase is coming for a house hold connection.help me............
