Interested to Buy Any Domain ? << Click Here >> for more details...
what is the function of a starter in a motor?
explain RLC circuit.
- 14 Answers
- 76706 Views
- I also Faced
- E-Mail Answers
Answer Posted / ibekwe solomon
A starter is basically used to reduce starting line current
when ever a motor is swicthed on in other to prevent the
coil from burning out because the starting line current is
usually 6times greater than the rated current for motor.
| Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
What is the pro & con of having 11kv & 33kv incoming, and what is the adv & disadv. of converting from 11kv to 33kv.
What is the dc grounding system and what is diff between AC/DC grounding system?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
what are the difference between PLC and embedded
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
What is the vector group of a transformer,how can it be found out?
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
i want to know how to determine that a surge arrester work properly in 11kv system. and how to test a 12kv surge arrester
why constant voltage transformer should be start without load? and if started then what will happen?
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
What is PQA???Applications........
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
