Interested to Buy Any Domain ? << Click Here >> for more details...
what is sf6 where it is use & working or function ?
- 5 Answers
- 9454 Views
- I also Faced
- E-Mail Answers
Answer Posted / prashanth
SF6 can also be used in Current transformers as insulation
media..
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
what is the difference b/w ground & virtual ground?
for 5KW resistive load can anyone please suggest me whether to go for UPS/Inverter or Generator depending upon cost calulations
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points
defination of lines
How to measure the earth resistance value in a concrete pavement(flood light area)?
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
why the electrolyte level in lead acid battery is maintained 2.5 cms above electrodes?
Refernce currents are to be generated using refernce cueernts how can this be done??
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
What is the range of the stator resistance of 3 phase induction motor?
Why AC & DC capacitor are use in UPS ??????????????????
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
