Interested to Buy Any Domain ? << Click Here >> for more details...
I try to check the three phase voltage in multimeter, in
125A isolator switch incommer. first i touch R phase, and
then i touch Y phase using multimeter, the moment i touched,
it blasts and that moment i got blindness. multimeter
selector position is correct(750V AC MODE AND RED PROBE WASS
IN v AND BLACK PROBE WASS IN COM. MODE. COULD ANYBODY GIVE
ANSWER FOR THIS TO AVOID FURTHER ACCIDENTS PLEASE?
- 2 Answers
- 5693 Views
- I also Faced
- E-Mail Answers
Answer Posted / pillay
your selector switch position was correct ,by right the
multimeter should have given you the voltage reading ,but
than some multimeter comes with a separate probe socket for
testing of amperes. maybe maybe, the probe was wrongly
plugged into this socket.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How can we findout the maximum efficiancy of Transformer? At which load?
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?
What are the components of feedback control system?
sir my exam is on 19/6/2013 under electrical branch pls send me sample aptitude questions as well as sample technical questions for jindal steel and power company
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
what is servo motor and how to work it.
What is EMC filter in VVVF Drive ?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
why three phase capacitor takes unbalanced current in capacitor bank?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
Whether should be the oil level in OCTC transfomer? It should be upto winding immersed completely or should be upto tap changer s/w? How it will affect the performance of the transformer. Rating may be 33KVA
What is the difference between diode and a transistor in terms of the direction of current flow?
what are the ''pitting rings''and how cn they be controlled in a series generator
If any one's require of phoenix contact like( relay , termilnal block , surge protection device ) , product please contect me 09878206357 chetan verma
