Interested to Buy Any Domain ? << Click Here >> for more details...
the question is about buchloz relay
why we called it buchloz relay
- 7 Answers
- 14770 Views
- HIL, I also Faced
- E-Mail Answers
Answer Posted / vijayppatel13
because it found by Max Buchloz Engineer,
so its called buchloz relay
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
1.what is mean by 8/20 micro sec waveshape
What is The Resistance Formula
why power not passes in plastic and rubber material
What are the properties of a resistor?
what is the purpose of silicon dropper used in battery charger?
In how we connect watt meter for open & short circuit test of a single phase transformer.
What is the resonant peak?
what is your aim
percetans
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
Difference between transition and diffusion capacitance
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
What is dc current source? Differentiate between ideal and non ideal current sources?
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
