Interested to Buy Any Domain ? << Click Here >> for more details...
how to derive kg/cm2 to mmwc? complete derivation.
- 11 Answers
- 42014 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / venkatesh
THIS IS USED FOR TANK ONLY....
1.02KG/MM2=1 BAR
1 BAR= 1000MMWC
| Is This Answer Correct ? | 21 Yes | 25 No |
Post New Answer View All Answers
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
flow transmitter formula?
I have energy meter for educational project having 0.5s class but my friend need 0.2s class meter , which one is good for that purpose and what is the actual difference of that two classes , need very easy example also.??
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
How is PH sensor works ?
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
why is an oxygen sensor used in a boiler stack
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
