what is is the potential diffrence between two phase ?
- 3 Answers
- 5351 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / dinesh kumar
Not only 415,
11 KV, 33 KV, 66 KV etc also
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
why the colour of insultor stack , petticoat is brown. Is it has some technical reason.
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
what is the formula of starting current of 3phase and 1 phase motor???
How to set a Zone 1 distance relay for distribution feeder?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
what id a dry type transformers and its function ?
How to design the no. of ceiling fans required in 5mtr X 10 mtr X 3 Mtr hight room?
Iin ESP why positive is grounded ? why not negative ?
what is conductor constant of raccun conductor
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
How to apply 'c' license and also explain what is difference between 'c' and 'b'license.i am also working in one of the private company.i have finished my diploma in 2014 .i have already finished in ITI electrician course.....
What is the diffrence (Technical & Construction ) between CBCT & Normal CT?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
