in elevator industries , how to calculate the required KVA
for the elevator (elevator spec- 40A module , motor of
13.5KW, 20A)
Answer Posted / k.prakashchandra
18 KVA as 0.75 pf is considered for motors.
Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
Why 9KV surge arrester having 7.65KV of MCOV?
Y phase plates are used in transmission line??? what is there need???
How is the connection of the tap changer on the HV side been made?
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
Explain Active power,reactive power,how its related to each other , & inductive ,capacitive.
Do any one know exacatly when the results for NHPC held on 8th march 09 for engineering trainees will be released ?. if so please post it, i'm eager to know it.
What if high voltage side circuit breaker of a ehv transformer instead of lvcb? Kindly elaborate.
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
What is the difference between isolators and electrical circuit breakers? What is bus-bar?
How i can calculate current of cable according to ares?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.