Interested to Buy Any Domain ? << Click Here >> for more details...
While testing concrete cubes why the load will be applied on
the opposite face of the casting surface of the cube?
- 6 Answers
- 10343 Views
- I also Faced
- E-Mail Answers
Answer Posted / furqan ansari
because opposit surfacec
is plain for applied load
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
How to calculate quantity of cement , sand and granite from concrete mix ratio and volume of work
what is the water cement ratio? how to calculate it? list the wt. of constructions materials including concrete both ordinary and light wt. concrete
what is the sequence of the activities in the typical under ground water tank including civil & MEP works.
If density of cement is 1500 Kg/m3, the how is specific gravity 3.15 ? (Density of water is 1000 Kg/m3)
What is structural frames or systems?
I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.
manhole height is 1500 mm and width of brickwork is 230 mm dia of manhole covering is 560 mm brick masonry 1:4 horizontal length is 1500 mm and plaster 12 mm thick on both side 1:3. how to estimate the quantity of brickwork with mortar cement and sand for manhole chamber.
What is the bowing depth after stressing of PSC Girder of various spans and various dia of strands?
How can calculate the requirement of steel bars of rcc slab for 1100 sq ft?
how to prepare site mix design
How can I make justification between using concrete grade c35 compare c37?
hi every body..i have applied for RRB section engineers CIVIL.i wanna prepare for that,so can any one suggest me some books and where can i get the syllabus for this..i would be vry greatful if any one can help in this regard
What is proportion of PCC Grade G?
Can we weld hot rolled steel ASTM A615 ? Please Give the detail answer please thanks alot
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
