Q- In the process of checking AC through Phase Tester our
body is the part of circuit but we don't recevie Shock, Why ?
Answer Posted / kannan
there is a ballast resistor which is connected in series
with the testing terminal and the neon lamp, this limits
the current flow to the neon lamp, there to body & ground.
this is the one which protect you from electric shock. but
you cannot go on using the tester for any voltage. there is
voltage limitation, normally around few hundred volt, above
which you can get a shock.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
What is intrinsic safety mean.
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
What is zero elevation and zero suppression?
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
hiii.... can any one provide me previous years question paper of hindustan petroleum for instrumentation engineering???
Draw a group of instruments interlocked to a Pump & Motor?
What is wet leg condition and why is it used?
How to decrease opening & closing time of on/off valve?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
Galvanizing.