Answer Posted / sathishkumar
battery backup calculations
Assumption battery bank cumulative voltage is equal to load
voltage
Q=1.25*total load current/i.e 0.8)
where the q=total capacity of the Battery Bank in Amp.hour.
and 0.8 is Battery efficiency coefficient for Lead Acid
batteries.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
how to calculate the Neutral transformer impedance?
When we use 3 terminal resistor?
why zero sequence impedance measurement is not applicable for single phase GT
why the active power flow of some line is increased when the active power of out is cut ?
How npn and pnp transistor works
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
what is level 2 automation?
why d.c produces corrosion
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
How the capacitance og capacitor volatage transformer is decided?
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
why dimmerstate always connected in star connection? what will happen if it connected in delta?
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .