Interested to Buy Any Domain ? << Click Here >> for more details...
what is the function of starter & choke in the tube light
set & how choke give 1000 volts while switching on.
- 14 Answers
- 86818 Views
- ADNOC Abu Dhabi National Oil Company, IBM, I also Faced
- E-Mail Answers
Answer Posted / raj
the starter function is used simply step up the voltage
level at the time of starting by using resistor and
inductor phenomenon and at the same time the starter
maintain the voltage for excitation of gases molecules
after some time by comparable no energy drawn from source
| Is This Answer Correct ? | 20 Yes | 12 No |
Post New Answer View All Answers
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
what is the safety of voltage power transformer(2250KVA0
physical identification of HT & LT panel
what is formula to cal cute earth pit numbers and size of earth strip used in earthing?
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
What is the difference between the relay and the circuit breaker?
Difference between control junction box (cjb) and power junction box(pjb)?
lamination figures
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
how current is reverse from its normal direction during the fault?
how maney type tempereture measurement ?
please I wont know how to calculate the vector group for power transformer ZNyn11 best regard.
Which device of PlC does share load between DG sets when DG are running in perallel?
What is the function of auadag in a cro?
An automatic water heater is an example of which type of control system?
