why the discharge pressure of ID fan showing negative at fan
running condition.(boiler operating condition.)
Answer Posted / mithilesh kumar
hi frnd..
1st offall ur question is wrong..
actually suction of ID fan is in negative..
in boiler furnce draught maintain (-3mmwc to -5mmwc) with
the help of ID fan.ie it's create vaccum in boiler side..
and it's discharge goes to stack which is positive..
Is This Answer Correct ? | 15 Yes | 4 No |
Post New Answer View All Answers
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
HOW TO SOLVE PROBLEM WITH ENRAF LEVEL TRANSMITTER 854 ATG THAT PASSWARD DO NOT Exist INTO TRANSMITTER TO ADJUST LEVEL WITH PORTABLE PET 847, WRITTEN WRONG PASSWORD , I AM SURE THAT DEFAULT PASSWARD (W2=ENRAF2) IS THIS TRANSMITTER NEED TO REPLACE SOFTWARE AND HOW?
Identification of ss fittings, pilot valves, relief valve.
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
give me all the details about the interview and which type of question being asked
How to Calibrate Temperature Switch in field
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
What is loop1 and loop2 in MTS LT?
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
How many interlocks at turbine side?
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
why we r opening HOT BYPASS valve during startup of a compressor?
what is the working principal of pribe