Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dananjaya
Power factor is the ratio of true power or watts to
apparent power or volt amps.
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
How to calculate that clean water supply in one Day from 150 KLD STP?
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
How to reduce -234126219.6403 MVAr generation and by what?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
What is transformation ratio what it describes?
What is inverse definite minimum time lag relay? Where is it use?
why industry prefer ht motor instead of lt motor.
What is meant by derating factor?
What is time response of the control system?
what is the voltage between earth & neutral in 3 phase electrical connection.
How to check the LM324 Ic
Lt motor sfu flashing reasons?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
what happen as when voltage drop(or may decrease) ? in case of atomic base theory?
what is positive , negative & zero equivalent system resistance
