sir, plz tell me how much kvar capacitor required for 1000
amp or 500 Kw load ? what is the formula ?
Answer Posted / saleem iqbal
plz identify your systems existing power factor and
targeted power factor which u want to improve, then apply
this formula
KW X (Tan phi 1 - tan phi 2)
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
How to perform a DC resistance test In Alternator and their proceduces?
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
i am going to correct power factor of 1600kw induction motor,when i calculate capacitance of capacitor it is three time more in star connection than delta. if motor is star connected which connection i shall adopt for capacitors and reason for adopt this connection
what are the available sizes of pin type terminal lugs in the market today?
WHAT IS THE DIFFERENCE BETWEEN GENERAL INVERTER AND SOLOR INVERTER TELL ME PLZ
What is a difference between indoor transformer and outdoor transformer of same rating
why three phase capacitor takes unbalanced current in capacitor bank?
Whether should be the oil level in OCTC transfomer? It should be upto winding immersed completely or should be upto tap changer s/w? How it will affect the performance of the transformer. Rating may be 33KVA
How to select circuit breakers rating eg. if i select a circuit breakers of capacity 40 amps DC with operating voltage 28 volts and if i what to use same circuit breakers for 300 Volts DC application what is the current rating of this circuit breakers.
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
a governer in an Ic engine controls the
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
Why compensation is necessary in feedback control system?