Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference between 3 wire and 4 wire RTD sensor?
- 12 Answers
- 43684 Views
- HTA Instrumentation, I also Faced
- E-Mail Answers
Answer Posted / lalit
FOR FULL COMPENSATION ONLY.
| Is This Answer Correct ? | 1 Yes | 8 No |
Post New Answer View All Answers
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
plz tell me clearly about PID.."when v have to change I value,D value,GAIN??
How many ohms are required for proper earthing?
send me last 5 years questions asked in rrb chennai, for section engineer
How to Calibrate Flow Switch in field
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
How flow can be measured with dp?
How oil line flow measured?eplain about instruments used and working principle?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
all questions related to instrument technician in any offshore oil and gas company.
what is the procedure of belt scale calibration?
Explain the key components of control loop?
Explain PID controller tuning & any one method used for it.
Manipulation of dead wt. tester double piston type.
Can I calibrate the Electromagnetic Flow Meter on line and How.
