Any can guide for QA/QC Inspector in oil & gas region, the
procedures, formats standards, design criteria, i search in
all enginees but i can't found wat i need?????????
Answer Posted / syed abdul mateen
If you are located in Jubail,Please check Aramco Desktop
and search in that your area and go through.Also you need
SABIC standards check and refer Quality procedure,hope this
should help you to start.
Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
What is the difference between uv and ir scanners? and what is the workig principle of both
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
why we are using digital signals for I/O & how to measure this signals is getting or not ?
what is the difference between magnetic flow meter and mass flowmeter
What is the use of GMV in turbine?
How to Calibrate Ultrasonic flow Transmitter in Field
What are the maximum packet size of: a) HART b) Profibus DP c)Profibus PA d) DeviceNet e) Foundation Fieldbus
why is not useing in boiler skin thermocople
How does temperature bath work? How does coil gets heated only by applying some current?
for oil & gas industries which zone is normally preferred? why? give its example?
I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.
how u calibrate pneumatic n motorized c/v?
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?