Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / c.satheeshgopalakrishna
the main difference was based on the load acting on it,and
the size.for smaller loads, screws are enough but incase of
greater-loads,bolts are to be used.
| Is This Answer Correct ? | 22 Yes | 2 No |
Post New Answer View All Answers
What parameters to be reported when we send lubricating oil for shore analysis?
How do you convert 95 feet into square feet?
how to check quality of steel?
How to disiegn DCV circuit ?
An elastomer is a polymer when its percentage elongation rate is ?
RRB JE GR-II OLD QESTION PAPER WITH ANSER
describe a type when u anticipated potential problems and development of preventive measure.
How are the pneumatic system and the hydraulic system similar?
what is lube oil cons./hours in diesel engine ???
Dfine the density of plastic?
what are the application or secification (temp/presure)for which IBR pipes should be used?
What is an ortographic drawing?
What are the important operational performance parameters in design of fuel firing equipment ?
Why must we pay attention when we drain steam in steam turbine. What factors are observed?
Difference ISDN and Brodband?
