Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gautam_etrx.engg
It is "Sillicon Controlled Rectifier". It's a four layer
device (pnpn) used for controlled firing.
| Is This Answer Correct ? | 16 Yes | 0 No |
Post New Answer View All Answers
what is the calibration procedure for magnetic flow meter @ onsite
Explain plc level and its type?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
What are different types of orifice plates? State their uses.
what is intrinscily safe system and where we use?
what is the difference between scaler and vector drive
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
How can you add value to this Industry if offered the job?
Why plc require in analog input 4-20amp & 0-10 volt?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
which type inter lock use in petrochemical refinery,and oil & gas?
send me last 5 years questions asked in rrb chennai, for section engineer
What is frequency factor in massflow meter? When using frequency output?
How many ohms are required for proper earthing?
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
