Interested to Buy Any Domain ? << Click Here >> for more details...
radial & axial vibration sensor output voltage is ac or dc volt?
- 8 Answers
- 16135 Views
- Vedanta, Voltech, I also Faced
- E-Mail Answers
Answer Posted / neelakandan
ac volt
| Is This Answer Correct ? | 3 Yes | 7 No |
Post New Answer View All Answers
what is the process for double acting cylinder pneumatic for 32' v/v
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
how to tune siemens sipart electro pneumatic positioner..plz tel me..
why we r opening HOT BYPASS valve during startup of a compressor?
What is offset in a control system.
what is 24vdc live and dry supply
What are different types of orifice plates? State their uses.
What materials are used in thermo wells?
how to design orifice plate?what is the equation?
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
what would be the minimum flow rate that we can measure on rotameter..?
