Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raghavi
The california bearing ratio test is penetration test meant
for the evaluation of subgrade strength of roads and
pavements. The results obtained by these tests are used with
the empirical curves to determine the thickness of pavement
and its component layers. This is the most widely used
method for the design of flexible pavement.
| Is This Answer Correct ? | 18 Yes | 0 No |
Post New Answer View All Answers
what is the mode of method of face bar measurement
How much for the BRC lapping in full yield and half yield < and which table to get it ?
what is derating factor in cable? what does it mean if derating factor is high/low in terms of thermal resistivity of soil?
can we make bricks using m10 grade cement concrete and what would be the ratio of raw materials used and price per brick ?
1)Why we can use half brick in 4inch wall and 2)why not in 9+inch brick wall
What is the exception critarea of cube?
where i can get material costs on weekly basis
pls mail some more tecnical qustions at msaranya2610@gmail.com
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
To pcc 11 ft x 24 ft .How many bags of cement, sand and aggregate required? And for roofing how many cgi sheets required?
What is the wall thickness of NP-3&NP-4 hume pipe as per I.S code
Describe the advantages and disadvantages of using plastic and timber fenders?
how much area can be platered by a mason for exterior
How to calculate the weight of sand am 20mm course aggregate in 1 c.m M25 concrete Which use 400 kg of cement ?
Can inverted beams used in pipes during construction?
