Interested to Buy Any Domain ? << Click Here >> for more details...
The temperature rise in the sys, which leads to …..
a) Increases stress& length b) increases stress but
decreases length c) Decreases stress & increase length
d) decrease stress & length
- 1 Answers
- 3810 Views
- Engineers India Limited, I also Faced
- E-Mail Answers
Answer Posted / sundar
option: b)
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
How to see the inductance in a transmission lines
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
Purpose of providing neutral isolation panel for parallel operation of diesel generator
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
What is the function of the circuit breaker failure relay?
Explain the method to keep noises low in a control system?
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
What is speed mode?
how we can set the IDMT relay.
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
differnce between single acting and double acting solenoid valves
why electronic instruments is more favorable than electrical?
