Why Current(Ampere) is chosen as Fundamental Quanties not
Charge(coulomb) ?
- 3 Answers
- 7131 Views
- I also Faced
- E-Mail Answers
Answer Posted / narendra mishra
amperes can be broken down
into coulombs and seconds, the coulomb cannot be broken
down (except to a
specific count of electrons or protons). Why does there
seem to be some
contradiction between the definition of a fundamental
quantity (a quantity
that can't be described in terms of another quantity)
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
what is the procedure of O2 sensor(ABB) calibration?
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
Difference between ultra sonic flow meter
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
can any send me a forbes marshall dtron 316 manual
which processor is used in dcs.
What is force balance principle? State some of its’ advantages.
What is zone,loop/fire alarm system?
Differentiate between ultrasonic flowmeter and radar type flow meter
How does temperature bath work? How does coil gets heated only by applying some current?
Why flow/pressure transmitter before control valve?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Which is your favourite subject & explain any one topic of it.
