Interested to Buy Any Domain ? << Click Here >> for more details...
what are factors to be consider to design a HT & LT motor?
- 1 Answers
- 3831 Views
- I also Faced
- E-Mail Answers
Answer Posted / pankaj jha
during designing it is the first most piority that how much
current it is going to take during noload & full load &
size of copper wire for winding,type of duty.
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER
What are the two segments of nyquist contour.
What are the special cables required for explosion proof wiring?
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
at which voltage level arcing ground is occurs ??????????
sir plz send some previous year questions of jspl.
What is the Minimum winding resistance of motors ( small & big)? referance range
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
Load break swicth maintenance procedure.
Difference between On Line capacitor and Station Type capacitor.
what happened when we supply a dc current in dc motor?? can it worked properly?
difference between servo motor and synchronous motor
What is difference between safe PLC and normal PLC
