Answer Posted / pasang, avit, chennai
Tappings of the transformer irrespective of either
Distribution or power transformers are on the HT side due
to the following reasons.
1. The HT windings have more No of turns than the LT
windings so that the flexibility of Stepping up and
stepping down is easier with more tappings.
2. The tap changing is easy and safe considering the
Voltage level and also the requisite voltage level either
step up/down can be acquired
| Is This Answer Correct ? | 12 Yes | 3 No |
Post New Answer View All Answers
Which type of motor is used in trains, what is the rating of supply used explain working principal?
how technical is calculated in 11kv line and lt line
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
Why CBCT rating is 50/1A
How many types of faults are there in 3 phase power system?
what is the eight bit unit?
can i use the six sigma method which is used in management area, in state estimation of power systems?
how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters
Is it possible to measure the voltage of a battery from a single terminal?
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
How grounding is different than earthings?
what is the voltage rating of chiller unit sensors
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
Why an ac solenoid valve attract the plunger even though we interchanges the terminal? Will the poles changes?
what is ground fault in ACB?
