Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / e.subash
Dear sir plz check your transformer OLTC Technical
specification and simply i tell difference
Transformer ratio = 3.3 KV/ 33 KV
Current = 785 A / 75A
if i provided OLTC in Low voltage side means
1) What is the OLTC size
2) Quanity of the material and Size of Contact points and
other things (Copper)
3)Transitent surges Compare When fault will happen
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box
(1)Can earth and be conected together (2) what is the diferent between earth & neutral
What is inductance?
bitumar
how single phase preventer works ?
i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result
what is meant by skew width in machines?
