Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / erarun
As per standard we have to maintain stable secondary voltage means load for uninterrupted power supply. To maintain secondary voltage constant we have to change the tap to higher value when supply (Primary) voltage is low.So this is first reason.
And second reason is that always LT winding put near to the core to provide lower insulation material rather than HT winding insulation.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is inter connected dc generator?
how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
what happen ehen synchronisation is done at below rated speed
Can we Co-ordinate relay in Load Break switch?
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
what is kvarh? Please define it With calculation General motors ?
determine two methods to find loose connection in operational electrical system?
how withstand of hi-pot test outputs of transformer wire 2.5mm
How does cost of generation from hydropower plant compare with other sources of electricity?
Define active and passive network?
Where servomechanism is used?
How to decide and select the different earthing wire size for the different types of earthing
WHAT IS ELECTRICAL MAINTAINTENCE ?
difference between crane drive and line drive.
When steam condenses and becomes water at the same temperature, the specific heat for the process in kJ/kg k is
