Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / harkishan
it is that condition in system at which the system shuts off
due to some error or complication in the suplly to make the
system stable from errorneous supply.
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
What is the use of control cable?
what is exact time to study dcs and plc cources
what are procedure of sox-nox calibration
What is hp & mp seperator .& what is its working principle ?
what is sliding spool valves?
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Explain the difference between plc and cnc?
What is the difference between uv and ir scanners? and what is the workig principle of both
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
Explain PID, ON/OFF, Controls
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
how to design orifice plate?what is the equation?
Explain the mechanism behind the turbine meter.
