Interested to Buy Any Domain ? << Click Here >> for more details...
in three pin plug 6 Amp. 220v AC rating.
why earth pin diameter is higher than ohter two pin? what its
purpose ?
- 6 Answers
- 9073 Views
- I also Faced
- E-Mail Answers
Answer Posted / vaibhav kumar
actually in first answer he tried to write directly proportional .....
logic is correct
but as the diameter increases rate of current flow also increases
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
Is the theorem applicable to ac sources?
what is the use of static frequency converter and static excitation equipment? and where it is employed? for what?
I WANT HOW CALCULATE TO CABLE FOR WELDING PLANT ?
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
Can we transmit digital signal to long distance ?
WHAT IS THE FAULT WHEN 100HP TURBINE MOTOR TRIPS, LIST THE FAULTS AND ITS TRABULESHOOTING TIPS.. MY AUTO TARNSFORMER STARTER TRIPS
Why the power factor improvement is so important in industrial loads
Why compensation is necessary in feedback control system?
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
what is the difference between droop mode and ischnorous mode in thermal powerplant?
What is the effect of interchanging core(made of steel) and winding(made of copper) material in case of transformer? Give proper explanation in regard to different losses in transformer.
How shall i select the value of capacitor or inductor in a system?
why is control bus bi-directional?
