what is the difference between power and distribution
transformer?
- 32 Answers
- 60481 Views
- L&T, VJTI, Wenke Electricals, I also Faced
- E-Mail Answers
Answer Posted / sanjay kumar jha
a power transformer is a transformer having rating of 33kv
and above,with high effi..,and capacity(kva)
a distribution trans.. is a trans which having low rating
like 33kv and less than this with low effi and always
stepdown type
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
Why High voltage are generate noise ?
what is lumped and distributed elements?
Hello Friends, How can we recognize the CT Star Point is S1 or S2 in case of Electro Mechanical Relays and what is meant by Restraining coil in relays and what is the purpose of that.. thank you in advance..
What is meant by impedance? difference between high & low impedance ?
draw a circuit diagram connecting transformer OLTC- RTCC- VCB-Marshalling Box otherwise Explain in words
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
what is the acceptable limit value for Desolve Gas Analysis/
how generator load test is conducted?what are the steps?
How I calculate the ELCB for circuit breakers?
What is a dominant pole?
11000volt DG set carnt kaise banvay
How to set a Zone 1 distance relay for distribution feeder?
