when the rheostat kept in minimum to maximum position in
motors what will happen?
Answer Posted / ramanareddy
actually rheostat means -diverting......if keep the rheostat in minimum position motor will run at rated speed....if rheostat in maximum position ,the motor will run above the rated speed ,so that speed make the motor damage....
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
What is synchro?
how we decide scurt (disc) of insulator with respect to kv rating
what are the installation procedure of high voltage power transformer,CT,CB&PT?
how does grading rings & spacers in transmission line works? Working Principle?
what is the difference between vector scale and vector diagram?
what is star delta starter? how it works? give its control and power diagram.
how much GROUND & NEUTRAL VOLT maintain in data center.
What is order of the system?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
What is meant by celling voltage & current in excitor ?
How work of capacitor in dc supply...???
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?