Interested to Buy Any Domain ? << Click Here >> for more details...
What will happen if the generator turns in a wrong
direction?
- 2 Answers
- 5668 Views
- I also Faced
- E-Mail Answers
Answer Posted / shyamkr
when a generator turns in wrong direction it will acts as
motor and it will draw power from the system inspite of
supplying power to the system.this may damage its the prime
mover connected to the generator.
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
impliment (AB)`+C to transistor representation
What are the three types of compensators?
WHICH SIZE A.B.CABLE IS USED FOR 11KV.
What types of question are done for diploma students in aptitude test
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
What is the meaning of HT Trivector Meter ?
What was the Dg set radiator and lube oil temperatures trip in ACB
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
Explain cos(theta) and Sin(theta)
What are diffrent type of road taxes?
HOW DOES THE ELECTRONIC ENERGY METER WORKS?
how invertor convert the dc into ac give brif detail
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
