how to measure low temperature(<100 dec celsisus) with non
condact sensor
- 2 Answers
- 4652 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.surya mutyalaro
for best practice/results.. rtd is suitable... cause is no
cold object/substance doesnt produce exact radiation... mat
b non contact type measurement gives measurement error.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
What are de-saturators?
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
What is the use of double seated valve?
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
what is scale factor of proximitor & unit of the vibration.
What is stripper & spilitter ? Diffrence in this.?
How digital input and digital output 's are working in dcs
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
what is the input of digital counter during the the calibration time?
What is the principle of capacitance type level transmitter?
What is zener diode? What is voltage regulator?
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
