Why do we use steel in Column?
Why HYSD bar is preferable than plain bar?
Answer Posted / sanatkumar tiwari
As column we know the column is compression member, but due
to lateral pressure there is a tension in column and to
avoid buckling due to axial load and shear crack we are
using steel in column. steel are also used to reduce the
cross sectional area of member.
As we know that HYSD steel is having high strenth than
plain steel, so it reduces the number of bar. therefore it
helps to avoid congestion and increase load carrying
capacity of column.
| Is This Answer Correct ? | 26 Yes | 4 No |
Post New Answer View All Answers
what is the hanekom repairing material after concreting work
When column of building is abutting the boundary line,then suitable footing advised is
Before casting a basement roof slab which is connected with retaining wall surcharge load (i.e. sand or earth filling) outside the retaining wall is prohibited because of––
for pretensioning which will yield first and same for post tensioning?
The definition of national highway
how much quantity of 1.5" nails and 2.5" nails are required for conventional formwork shuttering?
What is command line?
What is the Maximum %age of Steel in columns and beams ?
How to calculate concret slab? W l t(4mts*5*2fts) ratio m25 grade pls tell me procedure
57. Calculate the volume of a truck loaded with stone chips whose data are as follows– 5 Top Length - 13-9, 13-10, 13-09 Bottom Length - 13-11, 13-10.5, 13-10 Top width - 8-7.5, 8-8, 8-7 Bottom width - 8-7, 8-8, 8-7.5 Depth - 2-0, 1-11.5, 1-10, 1-11, 1 -10.5, 1-11.75, 1-11
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
can i make bricks using M10 grade concrete ? and what would be the cost of a brick if we use m10 grade concrete sand and aggregates ??
Difference between lime, distemper and plastic emulsion?
What is different between DI Pipe and CI pipe?
How many bricks are there in 100cft?