difference between limit state method and working stress in
terms of load
Answer Posted / a.mohamed buhari musa, sankar
In working stress method we are designing the structure for
the load acting on the structure.
In limit state method we are designing for the limit state of
safety and serviceability by applying partial safety factor
partly for the load or moment and partly for the stress
induced in the structure.
I don't know surely this is correct or not.
Is This Answer Correct ? | 19 Yes | 1 No |
Post New Answer View All Answers
what is the theoritical percentage of concrete cubes testing per day?
if a pipe those configuration (ASTM c 76 class b 450mm dia 2500mm length) fixing for water course those lining of water is 7000 running meter. my question is that if 8 joints of pipe ls leakage and we have not permission to stop the water so which treatment we apply on joint in that in condition.
What is the quantity of cement in mix m20 concrete?
How to calculate plastering for elevated water storage tank
how to calculate the strength of rebound hammer test reading in building construction ?
if the nitrates more than 45mg/l in water lead to disease then what is it called
types of piles detail,
how to calculate spacing rod in column
The foundations are placed below ground level, to increase?
What do you understand by “preset” during the installation process of bridge bearings?
what r the precaution for high in atp tempareture,low in atp tempareture
What is the crank length in the slab?
how to find hardness of water?why it should be determined?
what is the water cement ratio of 1:6 and 1:4 cement sand mortar. reply soon
give me the rate analysis for Bituminous Macadam and SDBC