Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / babu
ripple= unwanted ac signal
harmonics=other than fundamental freq
| Is This Answer Correct ? | 29 Yes | 4 No |
Post New Answer View All Answers
what are the 4 rules to start the motor?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What are the commonly used schemes for the bus zone protection?
what is the difference between droop mode and ischnorous mode in thermal powerplant?
why ss stablity limit is more transient stablity limit?
what is parellel power factor correction?
how are reversing the direction of dc motor
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
How much dc volt applied in cathodic protection system?
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
what is fault level of power system ?
what is the safety of voltage power transformer(2250KVA0
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
What is the significance of integral controller and derivative controller in a pid controller?
