why the indian frequency is 50 hz & U.S.Frequency of 60 hz
Answer Posted / noel
Basically in a historical sense it is because companies
especially westinghouse in the US and AEG in Germany were
the leading companies in producing electrical equipment at
the turn of the 19th century, and it is a complex story.
Many myths exist but it comes down to the use of frequency
to eliminate the flicker effect of lighting and the decision
by the companies to standardise at 60hz in the US and 50hz
in Europe.Before standardization numerous frequencies were
used by various generating companies.However most appliances
now come able with the ability to work between 50 and 60hz.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How halogen & merquery lamp works.
WHAT IS DEAD END IN PROTECTION?
Define corner frequency?
What is CCM in Electrical ? where can we use this material?
how many types control panel of a 132/33 kv substation
why ct ,cvt should be stored in a vertical position?
What is the type of feedback used in an op- amp schmitt trigger?
is it possible to have dc motors on single chip
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
what is the control circuit for operating the clean room air shower
What is the lower limit of break-down voltage of converter transformer.
Please define ampere?
how do prepare ongc exam.how is it question model.i am electrical. which part covering in electrical.tell me
Is Transol transformer oil comparable to nynas nytro libra?
how you configure motorvision relay (L&T make)from DCS