Interested to Buy Any Domain ? << Click Here >> for more details...
what is reactive power
is it good or bad for a system
- 5 Answers
- 16531 Views
- I also Faced
- E-Mail Answers
Answer Posted / shyamkr
reactive power is that component of apparent power which
moves to and fro between electrical source and energy
storing element.it doesn't do any useful work.it always
comes into action when there is reactive or energy storing
element.
when a load of low power factor is used it draws a large
amount of reactive power due to which the current in the
circuit increases which causes more losses in the circuit.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
What is Anemometer used to measure?
What is the basis for framing the rules of block diagram reduction technique?
Why is voltage is required to be within permissible range for an electrical equipment?
what is the difference between surge protection capacitor and surge arrestor
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
how to calculte capacitor range for single phase induction motors??pls tel
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
If you have an earth with pilecap then your resistance is really low. why and how?
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
Is a d.c.compound motor is use as a booster? how?
hello if any one have papers vof hpcl or sail, plz send me
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
