what is Diversity factor in electrical installations
Answer Posted / k.prakashchandra
Installation, not the station ? It can be taken as' Sum of
the peak loads of individual feeders or sections '/ 'The
peak load of the installation' and it is always greater than 1
Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
WRITEDOWN FEW RELY CODES
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
What is the difference between isolators and electrical circuit breakers?
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
why magnetising curve not start with zero voltage?
why single phase to grd test in HV cable?why not 2 phase at a time?
how to decide the capacity of accl
What is PEC??Applications........
What is phase cross over frequency?
Can we convert off line transformer to on line transformer
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
What is the estimated total hydropower potential of india?