Answer Posted / papesh kumar roul

due to reduce the
friction and heat
also.Beacuse when two
gearing parts
rotate ,it creates heat
and noise .for more
inquary call me
+918895360898(papesh)

Hoew to represent unilateral tolerance, as Bilateral tolerance in engg drawing...? Example: 1.295 +0.000 and -0.10, as unitolerance, write the value in bilateral tolerance?

1455

---

Explain mechanical refrigeration.

621

---

What is the cause of cylindrical liner overheating?

1570

---

When did you decide to become and mechanical engineer and why?

565

---

how to calculate GD square for pump?

1260

---

---

how to calculate bearing pre-load?

2567

---

Explain the difference between shear center flexural center of twist and elastic center?

646

---

mechanical question for the insrumentation

642

---

Greetings This question is about hydraulics and I request an expert to answer it. A simple hydraulic machine is made up of two heads, a larger one with a larger force inside a wider pipe and a smaller one with a smaller force inside a smaller pipe in width as in the second picture on this link: http://science.howstuffworks.com/hydraulic1.htm The question is this: what happens if the smaller head and the smaller force doesn’t exist but the smaller pipe is high enough to take all the liquid? For example the larger head is 1.00 sqr metre and can go down 1.00m under a weight of 100.00kg. The cross sectional area of the smaller pipe is 0.001 sqr metre. Now when the larger head goes down 1.00m, how high the liquid from the wider pipe can go into the smaller pipe of the cross sectional area of 0.001 sqr metre? Regards

1550

---

What are steam turbine parts usually come into damage?

1399

---

What is a liquid flooding in refrigeration system?

1848

---

How much water pressure will come from gravity feed tank, which is 10 metres high?

606

---

What is the use of try square?

714

---

Which are the sheets of metals?

656

---

How does a boat measure speed?

668

---